I would like to note that originally when I took the opening picture after the initial assembly and had simply clocked the entire handguard degrees instead of moving the rails which incorrectly placed the heat vents at the bottom of the forearm.
The remaining pictures show the correct installation of the forearm and the rail sections which can then be moved wherever you want them. Not being a fan of quad rails in general, these shorter rail sections seem a much more sensible setup all while maintaining both handling comfort and mounting flexibility and having them way forward get them out of the way of the hands.
The internal diameter of the tube is 1. An upper vise block and a quality barrel wrench will make barrel and handguard, scope and sight mounting an order of magnitude easier. I use the PRI upper vise all the time. This can all be accomplished with an Allen wrench, flash hider wrench, punch and barrel wrench depending on you AR accessories. Generally I work the barrel nut back and forth until I can get it as tight as possible while maintaining base port alignment and sometime this means actually backing it off just a bit.
Instead of buying a low profile gas block for my project rifle, I converted the stock DPMS Oracle gas block to low profile. Everywhere Threads This forum This thread. Search Advanced…. New posts. Forum list. Media New media New comments Search media. Install the app. Thread starter Strykervet Start date Mar 24, Forums The Armory. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser. Strykervet ain'T goT no how whaTchamacalliT. Full Member. Jun 5, 6, 4, 46 Pierce County, WA. I have a few questions about the PRI handguards in carbon fiber. One is a 7" carbine length "Delta" model it's triangular vs.
Is the 15" round handguard solid? Is it stable, as in it doesn't move or wiggle at the end of the tube near the muzzle when pressed? Is there ANY movement in that handguard at all? Is it rigid enough for that, and is that rail the same height as receiver? On the 7" Delta carbine model, does that front rail line up with the receiver? I'm under the impression the Delta isn't, but I'm not sure. Any other peculiarities about the PRI handguards I should be aware of? I've only used KAC before, so it's new territory.
Thanks for any advice! Strykervet said:. I have worked with the round styles from PRI for many years and more recently the delta series and they are tight as they get. As to the rail height matching In either event Click to expand Hey, thanks, everything you said matches what PRI's guy told me when I spoke with him.
He also said an SPR rail for the 15" tubes will be available in 3 months, maybe a little more. In Stock SKU: SKU: This Safety device with ergonomic design that helps divert gases and dirt away from the shooter.
This handle Best Sellers New. Redfeild-Leupold Replacement Torx Screws for Redfeild-Leupold replacement Torx screws for 1" Steel rings 4. The gas buster is This Mark 12 Mod 0 5.
0コメント