Solo cambia esos valores en el setup de la BIOS y debe de desaparecer. Hola: El problema de dejar sin usar mucho tiempo los equipos es que uno piensa en que no pasa nada, pero hay partes como los capacitores que, por su naturaleza quimica, siguen trabajando, aunque les quites la corriente y la pila del BIOS. Ademas tienes la humedad, calor y polvo, que no perdonan, y que se meten por donde sea.
Dale una buena limpiada a los cables y a los conectores de la placa con limpiador de circuitos electronicos y una brocha delgada no muy suave, para eliminar posibles sedimentos que pudieran obstaculizar el reconocimiento de las unidades. In my years working with computers I came across this problem numerous times and had no problem fixing it.
Most of the newer hard drives come with a smart capability built in to the controller boards on the drives themselves.
If you go into your BIOS and you look at the advanced settings and the many options that are there, you might find an area where you can enable or disable Hard Drive Smart Capability.
My suggestion to you is; go under the hood and double check your cables and jumper settings. As long as you have confirmed them to be in their correct positions, you go straight to the BIOS and enable Smart Drive Capability for your hard drive. You can continue using the pin cables when you turn this feature on. Also, set all your drives to be Auto detected and reboot the PC. If the message still appears you must now go to Device Manager and go to Systems. You will now see Primary and Secondary channels.
Click on the Primary Channel first and open the properties box. Go to advanced settings and make sure the transfer modes on device 0 and device 1 are set to DMA if available. Do the same for the Secondary channel as well and allow the PC to reboot. There is nothing wrong with your motherboard, the IDE Channels or the drives attached. This is configuration problem all the way. Good Luck. You must log in or register to reply here. Post thread. Anyway, this is the bios problem.
Prakash Srinivasan Posted April 9, 0 Comments. Dear all. Please check connection for IDE cable in both side. Robert Porokar Posted April 9, 0 Comments. Your power supply is failing. Hi suresh saladi, You check the following, 1 Check the IDE cable connection ,whether it is connected properly on both the sides i.
Register or Login. Welcome back! Sign in with Email. You should have. The 80 is finer lined than the Put an 80 in and the message should go away.
As for the other problem I have principles. And if you don't like them I have other principles!! Quote from: ale52 on June 15, , AM. Check drive s settings in the jumpers. An 80 conductor cable is necessary for CS cable select. Otherwise, replace the cable.
0コメント